Your circuit breaker panel protects your home from problems caused by external power surges, circuit overload, and short circuits.
Your circuit breaker panel protects your home from problems caused by external power surges, circuit overload, and short circuits. A breaker cuts off the power to a circuit by tripping when it detects a circuit overload. If your circuit breaker panel fails, the electrical wires can get so hot that they start a fire.
Unfortunately, this breaker failure happens every year in homes equipped with Federal Pacific Electric (FPE) Stab-Lok panels. Despite this information and the number of electricians and home inspectors who warn against this equipment, FPE Stab-Lok panels were never officially recalled.
How to Tell If You Own a Federal Pacific Electric Stab-Lok Panel
Millions of homes were built with FPE Stab-Lok panels between 1950 and 1990. If your home was constructed during this time frame, then it may contain one of these panels.
Usually, Federal Pacific or FPE will be written on the box’s front cover. Inside the box, look for a label that says, Stab-Lok.The breakers will have a red stripe across each switch.
Problems With Federal Pacific Electric Stab-Lok Panels
The Consumer Product Safety Commission (CPSC) began an investigation in the early 1980s and hired electrical experts to test FPE Stab-Lok breakers installed in homes from 1960 to 1985, which did not fully comply with Underwriters Laboratories, Inc. requirements. Fifty-one percent of the tested breakers failed to trip.
Doubt Surrounding FPE Stab-Lok Panels
Even though the CPSC investigation closed, one member of the testing team, Jesse Aronstein, continues to speak out about the dangers of FPE Stab-Lok panels. An electrical engineer with a doctorate in materials science, Jesse cowrote a peer-reviewed paper to illustrate the fire damage that the panels cause. Based on information collected from fire reports, Jesse and coauthor, Richard Lowry, estimate that FPE Stab-Lok panel failures result in as many as 2,800 fires, 13 deaths, and $40 million in property damage annually.
Reliance Electric Co., FPE’s parent company, provided additional information that leads one to doubt how safe these panels are. Reliance Electric Co. has stated that FPE obtained the Underwriters Laboratory seal of approval for its Stab-Lok breakers “through the use of deceptive and improper practices.”
It’s also worth noting that the CPSC issued a more recent statement in 2011 regarding their earlier investigation, stating that it was closed “without making a determination as to the safety of FPE circuit breakers or the accuracy of the manufacturer’s position on the matter.”
Is It Safe to Own an FPE Stab-Lok Panel?
The trouble with an FPE Stab-Lok panel is that it can function perfectly fine — until suddenly it doesn’t. It only takes one short circuit or overcurrent.
CPSC recommends getting this type of panel inspected by a qualified electrician “to look for any signs of overheating or malfunction among the circuit breakers.” However, after testing over 4,000 breakers, Jesse states that you can only identify a defective Stab-Lok breaker by first removing it and then testing it. This process can be more expensive than installing a new, less risky panel, so in many cases, it makes more sense to replace an FPE Stab-Lok panel.
DAVID PRUITT is the service manager with All Electric Services, a Central Florida five-star electrical contractor since 1980. For service, visit AllElectric.com or call 407-379-1700.
Want More Information?